REX, Multi-Frequency Pipe & Cable Locator
Rex is a multi-frequency locator with a price tag comparable to single-frequency locators. The sleek design of the transmitter is less than 2" thick and weighs less than 4 lbs. At slightly over 7 lbs., the entire system fits easily into a custom shoulder bag. Rex offers advanced features to suit almost any type of locating challenge, while emphasizing portability, size, and convenience. The receiver collapses for portability and expands for full functionality, and the transmitter packs up to 5 watts output power, multiple frequencies, and an inductive antenna in a flat and lightweight package.
REX Includes Only:
- Receiver & Transmitter
- Holster (p/n: PC10012)
- Conductive Clip Assembly (p/n: TM70000) which includes Standard Conductive Clips - C91010 (Red) and C91011 (Black)
- Soft Shoulder Bag (holds receiver, transmitter, accessories)
- Ground Stake (p/n: 208263)
- Power Supply & Cord for Transmitter charging
- Rex Receiver: 1 – 9V Alkaline Battery (in unit) (p/n: B11013)
- Rex Transmitter: 1 – Rechargeable NiMH pack (12V) (in unit) (p/n: FD50040)
Features:
- Ultralight Design: Receiver + Transmitter = Under 7lbs
- Compact & Portable: Receiver retracts for easy carrying
- Multi-Frequency Versatility: 512 Hz, 33 kHz and 82 kHz plus 50/60 Hz passive and 512 Hz sonde detection.
Passive 50/60 Hz
In passive mode, the transmitter is not used at all. Instead, the receiver searches for an appropriate harmonic of 60 or 50 Hz signals (factory preset). These signals are typically present in energized power cables, making it possible to locate them without using a transmitter to impose a tracing signal onto them.
Conductive
In conductive mode, the transmitter imposes a signal of the selected frequency onto the pipe or cable to be traced. It does so by making direct contact with the pipe or cable at a point where the pipe/cable comes up to the surface of the ground (a transformer box, a water hydrant, a telephone switch box, a gas meter, etc.). The circuit is closed by providing a return path with a stake that is buried in the ground near the transmitter.
Inductive
In the inductive mode, the transmitter imposes a signal of the selected frequency onto the pipe or cable to be traced. It does so by energizing an inductive antenna built into the case. The transmitter is placed on the ground in a direction perpendicular to the pipe or cable being traced. The inductive antenna then induces a current onto the pipe or cable. In this mode, it is not necessary to provide a return path for the induced current to the transmitter. The induced current will travel on the pipe or cable for a certain distance, making it possible to trace it.
Sonde
In sonde mode, the transmitter is not used at all. This mode is used to trace nonmetallic pipes, or metallic pipes where other modes are inapplicable or inefficient. A small beacon transmitter, or sonde, is pushed through the pipe, and the receiver searches for the signal emitted by the sonde.
Since the signal being traced by the receiver is produced by the sonde and not travelling along the pipes, there are some differences in the way the receiver is used. Due to the nature and strength of the sonde signal, it is necessary to have some idea of where the sonde is (in order to narrow the search area to a radius of several feet centered on the sonde).