30205650 115 VAC 2-wire CAROT Compatible Responder for System 75/85 Digital PBS Application
The Model 2056 Universal Test Line Responder combines the test and measurement capabilities required by most network testing systems in one compact unit. The programmed flexibility of the Model 2056 allows one responder to provide the testing termination for the multiple applications existing on modern telecommunication networks in the Telco, InterExchange Carrier and Private Network environments.
- 56-Type (A or B) 105 Test Line Responder
- Fully CARROT Compatible
- Meets AT&T Compatibility Bulletin 106
- Access Line/SW/PBX Loss Compensation
- MF- and DTMF-Compelled
- Tests Supported:
- Two-way Loss
- 3-Tone Gain/Slope
- Two-way Noise
- C-Notched Noise
- C-Message Noise
- Provides Quiet Termination
- Peak-to-Average Ratio (P/AR) Source
- Echo Canceller
The Model 2056 can be located at any dial-up 2-Wire point in the network. In a 2-Wire installation, supervision may be either loop or ground start with the connection made through a barrier terminal or RJ-11C jack.
During installation the send and receive functions can be calibrated to compensate for loss in the access lines betweenhe responder and the trunk under test on the network side of a PBX/SW. This allows testing to indicate results of only the loss associated with the trunk under test. A factory precalibration can be performed to compensate for known fixed losses, such as, those found in AT&T's System 75/85 Digital PBXs, where gain is inserted in one direction and loss in the other during the digital-to-analog conversion process. With this compensation capability, network-wide testing parameters can be customized for standardization of testing results on similar type trunks.
The Model 2056 also has the unique ability to originate a test call. This is accomplished by accessing the unit through a dial-up connection, entering a specific trunk through a maintenance port/station, and terminating the call. The Model 2056 will then go off-hook and dial the entered dialing sequence to process a call back to either the originating test controller, such as, the Wilcom T328 Master Test Line and Controller, or to a craftperson. When the call is answered, the unit is then ready to begin transmission in an automated or manual compelled mode.
Private network managers have recognized that 105 type responder testing has become the industry standard for transmission testing. Larger users of AT&T's SDN networks have elected to purchase Wilcom responders for compatibility with AT&T's CARROT System. Inter-Exchange Carriers have also standardized on 105 type testing for inter-machine trunks and customer access lines where private network customers have provided these compatible responders. In special cases, some Inter-Exchange Carriers have allowed access to 105 responders with one-way access lines in the carrier switch.
The Model 2056 UTLR is the most economical testing termination available for testing customer DID and DOD trunks to most PBXs. Utilizing the CARROT or Wilcom T328 testing systems, this unit provides the full 105 type test line termination for testing. Since the Model 2056 has thecapability to originate a test call, the unit can be remotely commanded to dial a direct trunk selection sequence from a PBX/Switch station, trunk or maintenance position, access a specific DOD trunk, and process a call to a Wilcom T328 Master Test Line & Controller. The T328 MTL&C can be programmed to answer an incoming call from the Model 2056 Responder and will begin to perform complete bi-directional transmission testing. This application is currently being used by telcos to test customer DID and DOD trunks.